House types
Rising damp in terraces and old brick houses
The tide mark on a terrace wall is two problems travelling together, water and the salt it carries. The usual cure, a coat of hard cement render, treats neither and worsens both.
Every inner-city terrace has the wall. It is usually the party wall in the hallway or the back room, and it has been replastered more times than anyone remembers. The paint bubbles at knee height. There is a faint white bloom on the skirting. A previous owner has fixed timber panelling over the worst of it, and behind the panelling the plaster has the consistency of damp biscuit.
Unlike a brick veneer house, a terrace is solid masonry from the footing up. Its walls are thick, porous and in direct contact with the ground. The standard reference on what happens next is a technical guide by David Young, Salt attack and rising damp, prepared for the Heritage Council of NSW, Heritage Victoria, the South Australian heritage department and Adelaide City Council. It is written for heritage buildings and says plainly that its principles apply to older buildings generally. It is also free, and anyone about to spend money on a damp wall should read at least its opening section first.
Two problems, not one
The guide's title names them separately on purpose. Rising damp is groundwater drawn up into a wall by capillary action through the pores of the brick and mortar. Salt attack is the damage done when that water evaporates from the wall surface and leaves its dissolved salts behind. The salts crystallise in the pores just under the face of the brick or plaster, and the growing crystals break the material apart from within. Water alone makes a wall wet. Salt is what makes it crumble.
The guide observes that the salts are not always apparent to the casual observer, so their role often goes unappreciated. That is the source of most failed repairs. A wall can be made drier and still go on decaying, because the salt already in it keeps cycling with every change in humidity.
The damp-proof course, and how it gets bridged
Brick houses are built with a barrier near the base of the wall called a damp-proof course, or DPC. In many nineteenth and early twentieth century houses it is a layer of tar and sand; the guide's cover carries a photograph of a suburban Melbourne wall in which it shows as a dark line above the third course of bricks. Other houses have slate, and some of the oldest have nothing.
A DPC can fail with age. More often it is still working and has simply been bypassed. The guide calls this bridging, and its diagnostic questions include whether there is "an existing DPC that is buried or otherwise bridged". The common bridges will be familiar to anyone who has renovated a terrace.
- Ground or paving raised above the DPC line, often by generations of new surfaces laid over old.
- A garden bed built against the wall.
- Render or plaster carried down past the DPC to the ground, giving water a path around it.
- A concrete floor poured against the inside of the wall, replacing a ventilated timber one.
The guide's housekeeping advice gives a figure to aim for: maintain about 200 mm between the DPC and ground level.
The guide's order of work
The guide condenses its method into what it calls the Seven Key Steps. The sequence is the point: the cheap, reversible measures come first, and cutting into the wall is the sixth step, not the opening move. Taken from the guide's own summary, the order runs like this.
- Diagnose accurately. Is it rising damp, or falling damp from a leaking gutter or parapet, or water penetrating sideways from a localised source, or condensation on a cold surface? Is there much salt, and where is it coming from? How bad is it: does it really need major works?
- Do the housekeeping. The guide calls this fundamental. Make sure gutters and downpipes work and that rainwater is carried well away from the base of the walls. Drain the site so nothing ponds against them. Minimise splash from hard paving. Find and fix plumbing leaks, sewers included, and check that existing underfloor ventilation is working.
- Remove excessive salts. Vacuum off surface deposits dry, then draw out salts near the surface with washing techniques, poultices of absorbent clay or paper pulp, or sacrificial plasters, renders and mortars that are designed to take the damage and be replaced.
- Review before going further. Allow at least one year of monitoring, and account for unusual events such as storms, floods and drought. Routine maintenance may prove to be enough.
- Insert a damp-proof course if it is still needed. This is step six. The guide lists the methods: undersetting with a mechanical DPC, slot sawing and inserting one, chemical impregnation, or active electro-osmotic systems. The new DPC should be at a level that also protects the floor timbers.
- Desalinate the wall. The seventh step. Where salts abound, a new DPC alone is not enough. The salt above it has to be removed as well, and the wall monitored annually and re-treated until salt levels are no longer harmful.
The guide is direct about proportion. There are many buildings, it says, with mild cases of salt damp that need attention but "do not warrant insertion of a damp-proof course", at least in the short to medium term. That sentence is worth quoting to any contractor whose inspection takes ten minutes and ends in a quote for chemical injection along every wall.
The repairs that make it worse
The guide's list of dos and don'ts is short and has the tone of someone who has seen the same mistakes for decades.
Hard cement render. The cover of the guide shows the base of a wall rendered in hard cement and captions it "a very common, but poor treatment". Dense render blocks evaporation at the bottom of the wall, so the damp climbs until it finds somewhere to get out, above the render line. The damage moves up and becomes harder to reach.
Cement mortar in lime joints. The guide says not to use hard cement mortar to repoint failed lime mortar joints, because that "will just drive the damp further up the wall and may also damage the bricks". Soft lime mortar is meant to be the sacrificial part of an old wall. Where the DPC is sound and the joints below it are eroding, the guide's prescription is repointing in a weak lime and sand mix.
Sealers. On water-repellent coatings the guide's advice is five words long: "don't even think about" it. A sealed face traps salt and moisture behind it.
The garden. A watered garden on the other side of a wall makes salt attack worse, and the guide adds that salt from inorganic fertilisers contributes to the decay.
It also gives a reason to act that goes beyond plaster. Damp walls increase the risk of fungal rot and termite attack to floor timbers, so, the guide says, always check beneath timber floors.
Getting quotes for a damp wall
Damp treatment attracts specialists who sell one product. A sound quote for an old house should show that the contractor has worked through the early steps: where the DPC is, what is bridging it, what the gutters and ground levels are doing, and whether salt has been tested for. The guide notes that do-it-yourself salt testing is possible, which gives you a way to check a diagnosis.
Ask what plaster and mortar will be used and whether they are lime-based. Ask what happens to the salt. And ask what the contractor would do if the job were limited to housekeeping and a sacrificial render for a year. If the answer is that nothing short of injection will work, get a second opinion from someone with heritage masonry experience.
Where the wall is a party wall, both owners share it, and work that cuts into it or changes the ground level on one side affects the other. Talk to the neighbour before the contractor. On the evidence of most terraces, their side has the same tide mark.
Questions readers ask
Can I just replaster the damp section?
Replastering with ordinary hard plaster or cement render hides the problem for a short time and tends to push it higher. If you replaster as part of a treatment, the heritage guide's approach is a sacrificial plaster or render intended to absorb salt and be renewed.
Does every damp wall need a new damp-proof course?
No. The guide says many mild cases do not warrant inserting one in the short to medium term, and it places DPC insertion sixth of its seven steps, after diagnosis, housekeeping, salt removal and at least a year of monitoring.